T+A PA 3100 HV Integrated Amplifier
19000,00 €
The T+A PA-3100 HV is a further development of the PA-3000 HV and is identical in most modules. The immediately visible difference is two VU meters in the front, which display the output power per channel logarithmically in watts at 4 ohms. In addition, a new concept for the analogue converter part and the voltage supply was developed similar to the A-3000 HV, which allows the PS-3000 HV to be connected and the stability and performance of the entire voltage supply to be increased again.
Overview
On request, the T+A PA 3000 HV and the T+A PA 3100 HV can also be equipped with high-end phono preamplifier modules, which have different circuit stopologies for MM or MC systems. It is also possible to install the analogue signal processor module from the T+A P 3000 HV for channel-separated sound control and loudness functions. The all-metal infrared remote control F3001 is supplied.
Technology
As in the T+A P 3000 HV, the circuit topology of the amplifiers is based on a cascode differential amplifier with hand-selected audio J-FET transistors and completely discretely constructed stages without an operational amplifier. This circuit concept and the quality of the components means that virtually no over-all-counter-coupling is necessary. Thanks to its high operating voltage, the HV technology also allows extremely high linearity as well as an extremely high dynamic range. Signals up to 60 Vpp can be processed undisturbed.
In the T+A HV series, switching and switching functions in the signal range of gas-tight encapsulated gold contact relays are adopted which, even after many years of operation, do not have any contact problems due to corrosion, dust, etc. and no ageing.
In the preamplifier, bi-stable relays are used in which no permanent coil current flows anymore and thus also no inductive impairment of the audio signals can take place. Due to the integration of the relays directly into the circuit, the signal paths are optimally short and there are no cable paths, such as conventional volume potentiometers. The volume control is also built with discrete precision resistors and gold contact relays, so there is absolutely accurate channel balance, no noise and no distortion.
The entire control electronics are deeply recessed and shielded in the 40 mm thick and fully milled front panel, on the front of which is the luminous and dimmable display (VFD) made of glass with wear-free sensor buttons.
| Pre-amplifier stage | |
| Frequency response + 0 / – 3 dB: | 0,5 Hz –300 kHz |
| Signal / noise ratio: | 105 / 110 dB |
| Total harmonic distortion: | < 0,001% |
| Intermodulation: | < 0,001 % |
| Channel separation: | > 90 dB |
| Nominal input sensitivity High level (RCA): | 7 x 250 mVeff ... 6 Veff / 20 kOhms |
| Nominal input sensitivity Balanced (XLR): | 4 x 500 mVeff ... 12 Veff / 5 kOhms |
| Outputs | |
| Headphones: | 50 Ohms |
| 1 x Recorder: | 250 mVeff / 100 Ohms |
| PRE out RCA: | nom 1 Veff, max 9,5 Veff / 50 Ohms |
| PRE out XLR: | nom 1,45 Veff, max 19,6 Veff / 50 Ohms |
| Output stage | |
| RMS output per channel into 8 Ohms: | 300 Watts |
| RMS output per channel into 4 Ohms: | 500 Watts |
| Peak output into 8 Ohms: | 380 Watts |
| Peak output into 4 Ohms: | 700 Watts |
| Power bandwith: | 1 Hz – 150 kHz |
| Frequency response + 0 / – 3 dB: | 0,5 Hz – 180 kHz |
| Slew rate: | 60 V/µs |
| Damping factor: | > 65 |
| Signal / noise ratio: | > 115 dB |
| Total harmonic distortion: | < 0,03 % |
| Reservoir capacity: | 120000 µF |
| Mains / Accessories / Dimensions | |
| Mains: | 110 V/60 Hz or 220/240 V/50 Hz |
| Standby: | < 0,5 W |
| Remote control: | F 3001 |
| Features: | Trigger input +5 ... 20V for external switching-on Input 4 can be configured in surround mode (Surround pass-through) connectivity for additional PS 3000 HV LAN connector for home-automation systems |
| Dimensions (H x W x D): | 17 x 46 x 46 cm |
| Weight: | 38 kg |
| Finishes: | Case: silver laquer 47 or titanium laquer 64 Heat sink: black 42 |
MAECENAS IACULIS
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
ADIPISCING CONVALLIS BULUM
- Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
- Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
- Diam parturient dictumst parturient scelerisque nibh lectus.
Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.
